Push-button Power Switch Breakout Adafruit 1400
Afbeeldingen
Artikel vergelijken
-
Geschikt vanaf 12 jaar
Geschikt vanaf 12 jaar
De minimaal aanbevolen leeftijd voor dit product.
Productbeschrijving
The Adafruit Push-button Power Switch is a tidy little design that lets you control a DC power source using an everyday tactile button. The breakout uses a latching analog circuit that is triggered by a push of the button. Press once to turn on, then press again to turn off. The circuit uses a 3A P-FET to connect and disconnect the IN pin to the OUT pin. Works great from 3V to 14VDC and up to 3A (although the FET gets a little toasty at continuous 3A draw) yet has only 0.5uA quiescent current draw.
Using it is easy: connect the power source to Ground and IN, then the load from Ground to OUT. We include a 12mm tactile switch that works well but you can solder in your own switch as well. Press the button (or short the button pins) to alternate between on or off. A on-board red LED will light up when active so you know its working. There's a fourth KILL pin, which you can use to turn off the load and/or keep it off even if the button is pressed. When 1 or more volts is applied it will instantly turn off the FET. This allows your project to turn itself off.
Comes with a assembled & tested bread-board friendly breakout board with four mounting holes, a 12mm tactile button, and some 0.1" male header you can solder to the board to plug it into a breadboard.
The power switch is an elegant way to control power to your project, but there are some things to keep in mind: since there is a pass FET, this is only for 3-14V DC voltages. This is not a mechanical switch so there is no air-gap isolation. There is a 'body diode' in the pass FET so if the load has a voltage on it that is higher than the input voltage, current will flow back to the input. There is built-in debouncing but very bouncy switches can be annoying as they will turn on and off fast instead of latching.
Voor meer info klik hier
Productspecificaties
Productinformatie
- Kleur
- Meerkleurig
Productinformatie
- Merk
- Adafruit
- EAN
- 9503469966869
Mogelijke vereisten instellen en gebruik
-
Kan zelfstandig met internet verbinden
- Nee
-
App vereist voor volledige functionaliteit
- Nee
Overige kenmerken
- Aanbevolen maximum leeftijd
- 99 jaar
-
Aanbevolen minimum leeftijd
- 12 jaar
- Adres verantwoordelijke marktdeelnemer in de EU
- Deze informatie volgt nog / Ces informations suivront bientôt
- E-mailadres verantwoordelijke marktdeelnemer in de EU
- Deze informatie volgt nog / Ces informations suivront bientôt
- Naam verantwoordelijke marktdeelnemer in de EU
- Deze informatie volgt nog / Ces informations suivront bientôt
- Taal handleiding
- Geen taal
- Telefoonnummer verantwoordelijke marktdeelnemer in de EU
- Deze informatie volgt nog / Ces informations suivront bientôt
- eWaste
- Ja
EAN
- EAN
- 9503469966869
Je vindt dit artikel in
- Categorieën
- Leeftijd
- 9-12 jaar, 13 jaar en ouder
- Merk
- Adafruit
Prijsinformatie en bestellen
De prijs van dit product is 13 euro en 33 cent.- Bestellen en betalen via bol
- Inclusief verzendkosten, verstuurd door VanAllesEnMeer.nl
- 30 dagen bedenktijd en gratis retourneren
- Wettelijke garantie via VanAllesEnMeer.nl
Vaak samen gekocht
-
Little Dutch stickers Jim & Friends - 3 stickervellen met speelachtergrond - stickerset€5,99Verkoop door bol
Rapporteer dit artikel
Je wilt melding doen van illegale inhoud over dit artikel:
- Ik wil melding doen als klant
- Ik wil melding doen als autoriteit of trusted flagger
- Ik wil melding doen als partner
- Ik wil melding doen als merkhouder
Geen klant, autoriteit, trusted flagger, merkhouder of partner? Gebruik dan onderstaande link om melding te doen.